Spartan Chemical Company, Inc.
Material Safety Data Sheet
SECTION I: PRODUCT INFORMATION
Product Name or Number (as it appears on label):
Product Division:
ANTIFOAM HP
Product Number:
2912 (Quarts);
2900 (Gallons & Five gallon pails)
IPG
Spartan Chemical Company, Inc.
Product/Technical Information:
1-(800)-537-8990
1110 Spartan Drive
Medical Emergency:
1-(888)-314-6171 (24 hours)
Maumee
OH
43537
Chemical Leak/Spill Emergency:
CHEMTREC 1-(800) 424-9300 (24 hours)
Shipping Description:
Cleaning compounds, liquid, n.o.s.
NFPA Ratings:
HMIS Ratings:
Health:
1- Slight
Health:
1- Slight
Fire:
0 - Minimal
Fire:
0 - Minimal
Reactivity:
0 - Minimal
Reactivity:
0 - Minimal
Pers. Prot. Equip.:
See Section VIII
SECTION II: HAZARDOUS INGREDIENTS
(Listed when present at 1% or greater, carcinogens at 0.1% or greater) All component chemicals are listed or exempted from listing on the "TSCA Inventory" of chemical substances maintained by the U.S. Environmental Protection Agency.
Chemical Name(s)
% W
CAS Registry No.
Table Z- 1 - A
NTP, IARC or OSHA Carcinogen
TWA mg/m
3
STEL mg/m
3
CELING mg/m
3
Polysiloxane antifoam
40-60
Proprietary
Not Established
Not Established
Not Established
No
SECTION III: PHYSICAL DATA
Boiling Point:
210
°F
Vapor Pressure:
Unknown
Vapor Density (AIR = 1):
Unknown
Solubility in Water:
Dispersible
pH:
8.0-9.0
Specific Gravity (H
2
O=1):
1.05
Evaporation Rate (but.ace.=1):
< 1
Percent Solid by Weight:
40-60
Physical State:
Liquid
Appearance & Odor:
Off-white opaque liquid, mild odor
SECTION IV: FIRE & EXPLOSIVE HAZARD DATA
Flash Point:
> 212
°F
Method Used:
ASTM-D56
Flammable Limits:
Not Established
Flame Extension:
N/A
Extinguishing Media:
Product does not support combustion. Use extinguishing media appropriate for surrounding fire.
Special Fire Fighting Procedures:
Wear NIOSH approved self-contained breathing apparatus and protective clothing. Cool fire-exposed containers with water spray.
Unusual Fire & Explosive Hazards:
Combustion products are toxic.
SECTION V: HEALTH HAZARD DATA
SECTION VI: REACTIVITY DATA
Stability:
Stable
Incompatible Materials:
Strong oxidizing materials
Hazardous Decomposition Products:
Unknown
Hazardous Polymerization:
Will Not Occur
SECTION VII: SPILL OR LEAK PROCEDURES
Steps to be Taken in Case
Material is Released or Spilled:
Dike and contain spill with inert material (sand, earth, commercial absorbent, etc.) and transfer to containers for disposal. Keep spill out of storm sewers and waterways.
Waste Disposal Method:
Consult an expert on disposal of recovered material and ensure conformity with federal, state and local regulations.
SECTION VIII: SPECIAL PROTECTION INFORMATION
Respiratory Protection:
None required
Ventilation:
Good general ventilation should be sufficient for most conditions. Local exhaust ventilation may be necessary for some operations.
Protective Gloves(Specify Type):
Rubber or other impervious gloves are recommended.
Eye Protection(Specify Type):
Splash goggles are recommended to prevent eye contact.
Other Protective Equipment:
For further guidance see 29 CFR 1910.132-138.
SECTION IX: SPECIAL PRECAUTIONS
Precautions; Handling & Storing:
Store in a cool dry place away from strong oxidizers and extreme heat. Keep containers sealed and stored upright when not in use.
Other Precautions:
Keep out of reach of children.
© SCC
09/22/2008
Name:
Ronald T. Cook
Title:
Manager, Regulatory Affairs
ANTIFOAM HP
Effective Date:
09/22/2008
Supercedes:
11/30/2005
Ref:
29 CFR 1910.1200 (OSHA)
Changes:
Review
This document has been prepared using data from sources considered technically reliable. It does not constitute a warranty, express or implied, as to the accuracy of the information contained herein. Actual conditions of use and handling are beyond sellers control. User is responsible to evaluate all available information when using product for any particular use and to comply with all Federal, State and Local laws and regulations.