Spartan Chemical Company, Inc.
Material Safety Data Sheet
Hide details for SECTION I:  PRODUCT INFORMATIONSECTION I: PRODUCT INFORMATION

Product Name or Number (as it appears on label):Product Division:
BOUNCE BACK
Product Number: 4330
Janitorial
Spartan Chemical Company, Inc.
Product/Technical Information:
1-(800)-537-8990
1110 Spartan Drive
Medical Emergency:
1-(888)-314-6171 (24 hours)
Maumee OH 43537
Chemical Leak/Spill Emergency:
CHEMTREC 1-(800) 424-9300 (24 hours)
Shipping Description:
Buffing, polishing compounds, liquid, n.o.s.
NFPA Ratings:
HMIS Ratings:
Health:
1- Slight
Health:
*1 - Slight; Chronic Hazard
Fire:
0 - Minimal
Fire:
0 - Minimal
Reactivity:
0 - Minimal
Reactivity:
0 - Minimal
Pers. Prot. Equip.:
See Section VIII


Hide details for SECTION II:  HAZARDOUS INGREDIENTSSECTION II: HAZARDOUS INGREDIENTS
(Listed when present at 1% or greater, carcinogens at 0.1% or greater) All component chemicals are listed or exempted from listing on the "TSCA Inventory" of chemical substances maintained by the U.S. Environmental Protection Agency.
Chemical Name(s)
% W
CAS Registry No.
Table Z- 1 - A
NTP, IARC or OSHA Carcinogen
TWA mg/m3
STEL mg/m 3
CELING mg/m3
*Diethylene glycol ethyl ether
1-5
111-90-0
140 (AIHA)
Not Established
Not Established
No

Comment: *This substance is subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 (SARA) and of 40 CFR 372.

Hide details for SECTION III:  PHYSICAL DATASECTION III: PHYSICAL DATA
Boiling Point:
212 °F
Vapor Pressure:
Unknown
Vapor Density (AIR = 1):
Unknown
Solubility in Water:
Complete
pH:
8.0-8.5
Specific Gravity (H2O=1):
1.01
Evaporation Rate (but.ace.=1):
<1
Percent Solid by Weight:
16-18
Physical State:
Liquid
Appearance & Odor:
Milky white liquid, floral fragrance



Show details for SECTION IV:  FIRE & EXPLOSIVE HAZARD DATASECTION IV: FIRE & EXPLOSIVE HAZARD DATA

Hide details for SECTION V:  HEALTH HAZARD DATASECTION V: HEALTH HAZARD DATA
Threshold Limit Value:
Not Established
Primary Routes of Entry:
Inhalation, Skin Contact, Eyes and Oral.
Effects of Overexposure-
Conditions to Avoid:
Causes eye irritation: Symptoms may include pain, redness, swelling and tearing.
May cause skin irritation: Symptoms may include redness, pain and swelling.
Harmful if swallowed: Symptoms may include nausea, vomiting, pain and diarrhea.
Inhalation of vapors may cause respiratory irritation, headache and nausea.
Contains diethylene glycol monoethyl ether which may cause central nervous system depression, liver and kidney impairment.
Avoid contact with eyes and skin. Avoid breathing product vapors or mist. Use with adequate ventilation. Do not taste or swallow. Wash thoroughly after handling.
Conditions Aggravated by Use:
Use of this product may aggravate preexisting eye; skin and respiratory disorders such as asthma and dermatitis.
Emergency & First Aid Procedures:
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses. Get medical attention.
Skin:
Remove contaminated clothing. Flush skin thoroughly with plenty of water. Get medical attention if irritation persists. Wash contaminated clothing before reuse.
Ingestion:
Do not induce vomiting unless advised to do so by physician or poison control center. Drink one or two glasses of water to dilute product. Get medical attention. Do not give anything by mouth to an unconscious person.
Inhalation:
In case of respiratory irritation; move person to fresh air. Get medical attention if irritation persists.


Hide details for SECTION VI:  REACTIVITY DATASECTION VI: REACTIVITY DATA

Stability:
Stable
Incompatible Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Thermal decomposition may yield styrene and acrylic monomers.
Hazardous Polymerization:
Will Not Occur.


Hide details for SECTION VII:  SPILL OR LEAK PROCEDURESSECTION VII: SPILL OR LEAK PROCEDURES
Steps to be Taken in Case
Material is Released or Spilled:
Small spills of one gallon or less may be flushed with plenty of water to sanitary sewer system (If permitted by local sewer regulations). Dike and contain large spills with inert material and transfer liquid to containers for recovery or disposal.
Waste Disposal Method:
Assure conformance with federal, state and local regulations.


Hide details for SECTION VIII:  SPECIAL PROTECTION INFORMATIONSECTION VIII: SPECIAL PROTECTION INFORMATION

Respiratory Protection:
Not normally needed when good ventilation is provided. However, if exposure limits are exceeded (see Section II) or if respiratory irritation occurs, use of a NIOSH approved respirator suitable for the conditions of use and substances in Section II should be considered.
Ventilation:
Provide good general ventilation. Local exhaust ventilation may be necessary for some operations.
Protective Gloves(Specify Type):
Impervious gloves are recommended to prevent skin contact.
Eye Protection(Specify Type):
Splash goggles are recommended to prevent eye contact.
Other Protective Equipment:
For further guidance see 29 CFR 1910.132-138.



Hide details for SECTION IX:  SPECIAL PRECAUTIONSSECTION IX: SPECIAL PRECAUTIONS

Precautions; Handling & Storing:
Keep from freezing.
Other Precautions:
Keep out of reach of children.

© SCC 09/22/2008Name:Ronald T. CookTitle:Manager, Regulatory Affairs
BOUNCE BACKEffective Date:09/22/2008Supercedes:06/30/2005
Ref: 29 CFR 1910.1200 (OSHA)Changes:Review
This document has been prepared using data from sources considered technically reliable. It does not constitute a warranty, express or implied, as to the accuracy of the information contained herein. Actual conditions of use and handling are beyond sellers control. User is responsible to evaluate all available information when using product for any particular use and to comply with all Federal, State and Local laws and regulations.