Spartan Chemical Company, Inc.
Material Safety Data Sheet
Hide details for SECTION I: PRODUCT INFORMATIONSECTION I: PRODUCT INFORMATION

Product Name or Number (as it appears on label):Product Division:
AQUASPORT WOOD FLOOR SANDING SEAL
Product Number: 5839
Janitorial
Spartan Chemical Company, Inc.
Product/Technical Information:
 1-(800)-537-8990
1110 Spartan Drive
Medical Emergency:
 1-(888)-314-6171 (24 hours)
Maumee, OH 43537
Chemical Leak/Spill Emergency:
 CHEMTREC 1-(800) 424-9300 (24 hours)
Shipping Description:
Buffing, polishing compounds, liquid, n.o.s.
NFPA Ratings:
HMIS Ratings:
Health:
1- Slight
Health:
*1 - Slight; Chronic Hazard
Fire:
0 - Minimal
Fire:
0 - Minimal
Reactivity:
0 - Minimal
Reactivity:
0 - Minimal
Pers. Prot. Equip.:
See Section VIII


Hide details for SECTION II: HAZARDOUS INGREDIENTSSECTION II: HAZARDOUS INGREDIENTS
(Listed when present at 1% or greater, carcinogens at 0.1% or greater) All component chemicals are listed or exempted from listing on the "TSCA Inventory" of chemical substances maintained by the U.S. Environmental Protection Agency.
Chemical Name(s)
% W
CAS Registry No.
Table Z- 1 - A
NTP, IARC or OSHA Carcinogen
TWA mg/m3
STEL mg/m 3
CELING mg/m3
Acrylic polymer
20-25
Proprietary
Not Established
Not Established
Not Established
No
*2-Butoxyethanol
5-10
111-76-2
240 (skin) 96
Not Established
Not Established
No
Dipropylene glycol methyl ether
1-5
34590-94-8
600 [skin]
909 (skin)
Not Established
No

Comment: *This substance is subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 (SARA) and of 40 CFR 372.

Hide details for SECTION III: PHYSICAL DATASECTION III: PHYSICAL DATA
Boiling Point:
210 °F
Vapor Pressure:
Unknown
Vapor Density (AIR = 1):
Unknown
Solubility in Water:
Complete
pH:
7.0 - 8.0
Specific Gravity (H2O=1):
1.036
Evaporation Rate (but.ace.=1):
<1
Percent Solid by Weight:
20-30 %
Physical State:
Liquid
Appearance & Odor:
Translucent emulsion, slight ammoniacal odor



Show details for SECTION IV: FIRE & EXPLOSIVE HAZARD DATASECTION IV: FIRE & EXPLOSIVE HAZARD DATA

Hide details for SECTION V: HEALTH HAZARD DATASECTION V: HEALTH HAZARD DATA
Threshold Limit Value:
Not Established
Primary Routes of Entry:
Inhalation, Skin Contact, Eyes and Oral.
Effects of Overexposure-
Conditions to Avoid:
Causes eye and skin irritation. Symptoms may include redness, pain and swelling.
Harmful if swallowed. Symptoms may include nausea, vomiting, pain and diarrhea.
Harmful if absorbed through skin.
Inhalation of vapors may cause respiratory irritation, headache and nausea.
Contains 2-butoxyethanol which may cause central nervous system depression with symptoms such as headache; dizziness; nausea and drowsiness. Exposure to 2-butoxyethanol may cause blood cell; liver and kidney damage based on animal data.
Do not get in eyes, on skin or on clothing. Avoid breathing vapors or mist. Use with adequate ventilation. Do not swallow. Wash thoroughly after handling. Observe recommended exposure limits.
Conditions Aggravated by Use:
Use of this product may aggravate preexisting skin; eye and respiratory disorders including asthma and dermatitis.
Emergency & First Aid Procedures:
Eyes:
Immediately flush eyes with water for at least 15 minutes. Remove contact lenses. Get medical attention.
Skin:
Remove contaminated clothing. Flush skin thoroughly with plenty of water. Get medical attention if irritation persists. Wash contaminated clothing before reuse.
Ingestion:
Do not induce vomiting. Drink one or two glasses of water to dilute product. Get immediate medical attention. Do not give anything by mouth to an unconscious person.
Inhalation:
Move person to fresh air. Get medical attention if irritation persists.


Hide details for SECTION VI: REACTIVITY DATASECTION VI: REACTIVITY DATA

Stability:
Stable
Incompatible Materials:
Oxidizing agents
Hazardous Decomposition Products:
Carbon oxides, nitrogen oxides
Hazardous Polymerization:
Will Not Occur


Hide details for SECTION VII: SPILL OR LEAK PROCEDURESSECTION VII: SPILL OR LEAK PROCEDURES
Steps to be Taken in Case
Material is Released or Spilled:
Dike and contain spill with inert material (sand, earth, commercial absorbent, etc.) and transfer to containers for disposal. Keep spill out of storm sewers and waterways.
Waste Disposal Method:
Consult an expert on disposal of recovered material and ensure conformity with federal, state and local regulations.


Hide details for SECTION VIII: SPECIAL PROTECTION INFORMATIONSECTION VIII: SPECIAL PROTECTION INFORMATION

Respiratory Protection:
Not normally needed when good ventilation is provided.
Ventilation:
Provide good general ventilation. Local exhaust ventilation may be necessary for some operations.
Protective Gloves(Specify Type):
Use of rubber or other impervious gloves is recommended to prevent skin contact.
Eye Protection(Specify Type):
Use of Splash goggles is recommended to prevent eye contact.
Other Protective Equipment:
For further guidance see 29 CFR 1910.132-138.



Hide details for SECTION IX: SPECIAL PRECAUTIONSSECTION IX: SPECIAL PRECAUTIONS

Precautions; Handling & Storing:
Keep container tightly sealed. Store in a cool, well ventilated area away from heat, direct sunlight and oxidizing agents. Keep from freezing.
Other Precautions:
Keep out of reach of children.

© SCC 06/01/2007Name:Ronald T. CookTitle:Manager, Regulatory Affairs
AQUASPORT WOOD FLOOR SANDING SEALEffective Date:06/01/2007Supercedes:06/30/2005
Ref: 29 CFR 1910.1200 (OSHA)Changes:Update Section II
This document has been prepared using data from sources considered technically reliable. It does not constitute a warranty, express or implied, as to the accuracy of the information contained herein. Actual conditions of use and handling are beyond sellers control. User is responsible to evaluate all available information when using product for any particular use and to comply with all Federal, State and Local laws and regulations.